Prikazivanje rezultata 1 do 17 od 17

Tema: problem with new dongle

  1. #1
    GSM Junior sorinm's Avatar
    Clan br.
    6252
    Registrovan
    Jun 2007
    Godina
    37
    Br. postova
    6
    Hvala
    0
    Pohvaljen 0 puta u 0 postova

    problem with new dongle

    hello

    first of all i have read all the post in this support section but i could not find any post with similar problem
    i recived my dongle 2 days ago
    the problem is that i can't unlock any phone
    6280, 6233 not even 6680
    i was using 6680 to test
    the problem is that the phone turns off and i have error like phone not found
    when i conect the pin from DATA(the one with button) the phone turns off
    i did this with 6680 just to be sure that i'm not making bad contact on RAP
    i even put pop-port rx/tx/gnd wires on the second cable (mini usb)
    but it is the same - phone goes off.
    any sugestions are wellcome


    after trying to unlock 6680 the counter of total phones unlocked is 3 but no phones unlocked so far

    br
    sorinm

    i also attached the picture vith the mesurements i made and it seems that there is a problem on the dongle
    i would like that somebody from dejan team to confirm about the problem
    Attached Images Attached Images
    Izmenio sorinm : 23-06-07 u 20:50

  2. #2
    GSM Junior Munze konza's Avatar
    Clan br.
    2792
    Registrovan
    Nov 2006
    Lokacija
    Zemun,Srbija
    Godina
    51
    Br. postova
    5
    Hvala
    0
    Pohvaljen 0 puta u 0 postova
    Citiram Original postovao sorinm
    hello

    first of all i have read all the post in this support section but i could not find any post with similar problem
    i recived my dongle 2 days ago
    the problem is that i can't unlock any phone
    6280, 6233 not even 6680
    i was using 6680 to test
    the problem is that the phone turns off and i have error like phone not found
    when i conect the pin from DATA(the one with button) the phone turns off
    i did this with 6680 just to be sure that i'm not making bad contact on RAP
    i even put pop-port rx/tx/gnd wires on the second cable (mini usb)
    but it is the same - phone goes off.
    any sugestions are wellcome


    after trying to unlock 6680 the counter of total phones unlocked is 3 but no phones unlocked so far

    br
    sorinm

    i also attached the picture vith the mesurements i made and it seems that there is a problem on the dongle
    i would like that somebody from dejan team to confirm about the problem
    Conect powered phone to dcu testpoint cable (6680 test phone no need testpoint)and try to read info.If no info on program try to change rj45 conector on testpoint cable or rj45 conector on box.I hope to solved problems with this.
    b/r Andrija

  3. #3
    GSM Junior sorinm's Avatar
    Clan br.
    6252
    Registrovan
    Jun 2007
    Godina
    37
    Br. postova
    6
    Hvala
    0
    Pohvaljen 0 puta u 0 postova
    i have talked to boban and i will send back the dongle for it to be checked


    br
    sorinm

  4. #4
    GSM Junior
    Clan br.
    3454
    Registrovan
    Jan 2007
    Godina
    46
    Br. postova
    4
    Hvala
    0
    Pohvaljen 0 puta u 0 postova
    Hi bro!

    I had the same problem as yours with my box (box was connecting and phone info readed normal, but couldn't unlock).
    I changed this capacitor with normal one - cause this one was damaged (when I dessoldered it measured 450ohm).
    I think all problems with the box comes from china shit parts that has been used in it

    BR,
    sid@rousse.spnet.net

  5. #5
    GSM Junior Munze konza's Avatar
    Clan br.
    2792
    Registrovan
    Nov 2006
    Lokacija
    Zemun,Srbija
    Godina
    51
    Br. postova
    5
    Hvala
    0
    Pohvaljen 0 puta u 0 postova
    Citiram Original postovao sid
    Hi bro!

    I had the same problem as yours with my box (box was connecting and phone info readed normal, but couldn't unlock).
    I changed this capacitor with normal one - cause this one was damaged (when I dessoldered it measured 450ohm).
    I think all problems with the box comes from china shit parts that has been used in it

    BR,
    sid@rousse.spnet.net
    Problem is with rj45 conectors.Try to chage on cable or box.Solved problem meny times with this solutions.
    b/r Andrija

  6. #6
    GSM Junior
    Clan br.
    3454
    Registrovan
    Jan 2007
    Godina
    46
    Br. postova
    4
    Hvala
    0
    Pohvaljen 0 puta u 0 postova

    Thumbs up

    Hi friends!

    please don't say all problems come from RJ45 connector (cause I'm 100% sure it isn't) - I only want to help other people that spent a lot of money for this box!
    I have changed my RJ45 with a new one (3com with gold plated pins + FTP shilded cable with same lenght as original, but still got some problems).

    After this I made several modifications:
    Please look at my posts regarding TP/clk cable modifications:
    http://www.gsmserbia.com/forum/showp...11&postcount=4
    http://www.gsmserbia.com/forum/showp...57&postcount=7
    also look at this photo regarding my second problem with short circuit capacitor I had to change (with Japan one - that's why it is bigger than smd, but stable working) in order to start my box working.

    And not to be misunderstood: I don't blame Dejan or anyone that made this box! I know that China parts are crap!

    Now unlocked 10 phones without any problems

    BR,
    sid@rousse.spnet.net
    Attached Images Attached Images

  7. #7
    GSM Junior sorinm's Avatar
    Clan br.
    6252
    Registrovan
    Jun 2007
    Godina
    37
    Br. postova
    6
    Hvala
    0
    Pohvaljen 0 puta u 0 postova
    hello
    sid advice was corect
    i changed the capacitor and the box is ok now - thanks !
    i have succefully unlocked one 6233 BUT i could not unlock any 6280
    i have allways 'phone can't be unlocked' - i'm using a good microscope so i rule out the problems with testpoint pads
    i allready changed the rj45 conector with a new one


    br
    sorinm

  8. #8
    ---Management--- MobileLand's Avatar
    Clan br.
    1
    Registrovan
    Aug 2005
    Lokacija
    Bar
    Godina
    41
    Br. postova
    1.683
    Hvala
    127
    Pohvaljen 94 puta u 45 postova
    Citiram Original postovao sorinm
    hello
    sid advice was corect
    i changed the capacitor and the box is ok now - thanks !
    i have succefully unlocked one 6233 BUT i could not unlock any 6280
    i have allways 'phone can't be unlocked' - i'm using a good microscope so i rule out the problems with testpoint pads
    i allready changed the rj45 conector with a new one


    br
    sorinm
    You used the conf file from ftp ???
    By the way 6280 have very nasty TP.

    BR

  9. #9
    GSM Junior sorinm's Avatar
    Clan br.
    6252
    Registrovan
    Jun 2007
    Godina
    37
    Br. postova
    6
    Hvala
    0
    Pohvaljen 0 puta u 0 postova
    Citiram Original postovao MobileLand
    You used the conf file from ftp ???
    By the way 6280 have very nasty TP.

    BR
    it is the same with 6233
    conf file is ok

  10. #10
    GSM Guru Lale's Avatar
    Clan br.
    288
    Registrovan
    Nov 2005
    Lokacija
    BGD Takovska
    Br. postova
    204
    Hvala
    6
    Pohvaljen 35 puta u 17 postova
    Citiram Original postovao sorinm
    it is the same with 6233
    conf file is ok
    Try the clean POP connector in phone.

  11. #11
    GSM Junior sorinm's Avatar
    Clan br.
    6252
    Registrovan
    Jun 2007
    Godina
    37
    Br. postova
    6
    Hvala
    0
    Pohvaljen 0 puta u 0 postova
    thanks to lale, boban, sid, dejan and god
    i manged to unlock few phones
    7 - 6280 and one 6233
    i made the same 'repairs' and modifications as sid did
    and i finally got these 6280 unlocked
    thanks again to all for the support

    br
    sorinm

  12. #12
    GSM Junior Raskal's Avatar
    Clan br.
    3406
    Registrovan
    Jan 2007
    Lokacija
    China-Banja Luka-India
    Br. postova
    11
    Hvala
    1
    Pohvaljen 0 puta u 0 postova
    Citiram Original postovao sid
    I think all problems with the box comes from china shit parts that has been used in it

    BR,
    sid@rousse.spnet.net
    i think you have no ideea what you talking about. china product are as u buy and test them. sure, some supplier cheating here but with the time know who is deliver good part and who not.

    I sold a lot jaf boxes i think there is less than 2% damage... and ALL are my box i make in china !!!

    Nokia phones are also made in china, how many are damaged...


    All i want to say it is a question of quality check, nothing more or less.

  13. #13
    GSM Master Inovator's Avatar
    Clan br.
    247
    Registrovan
    Oct 2005
    Lokacija
    ...root/home/Bjelovar
    Br. postova
    670
    Hvala
    20
    Pohvaljen 52 puta u 29 postova
    almost every electronic component nowdays comes from China, Taiwan and S. Korea

  14. #14
    GSM Junior
    Clan br.
    5548
    Registrovan
    May 2007
    Godina
    37
    Br. postova
    18
    Hvala
    0
    Pohvaljen 0 puta u 0 postova

    what is the value of the capacitor in the dejan box

    what is the value of the capacitor in the dejan box...
    and is it tyrue that we need to change it

  15. #15
    Balkan GSM Team Eprom's Avatar
    Clan br.
    487
    Registrovan
    Dec 2005
    Lokacija
    Srbija,Zemun,Bezanijska 18 service,Bezanijska 21 battery shop
    Godina
    51
    Br. postova
    6.474
    Hvala
    1.243
    Pohvaljen 1.577 puta u 891 postova
    Citiram Original postovao abuiesa
    what is the value of the capacitor in the dejan box...
    and is it tyrue that we need to change it
    http://www.gsmserbia.com/forum/showp...11&postcount=4

    No need to change only if you have demage box!!!
    b/r Andrija

  16. #16
    GSM Junior
    Clan br.
    6425
    Registrovan
    Jun 2007
    Godina
    36
    Br. postova
    1
    Hvala
    0
    Pohvaljen 0 puta u 0 postova
    i have new box but cant read any phone and with battery the same proplem rj 45 changed the same proplem

  17. #17
    GSM Junior
    Clan br.
    6826
    Registrovan
    Jul 2007
    Godina
    36
    Br. postova
    1
    Hvala
    0
    Pohvaljen 0 puta u 0 postova
    Citiram Original postovao sorinm
    thanks to lale, boban, sid, dejan and god
    i manged to unlock few phones
    7 - 6280 and one 6233
    i made the same 'repairs' and modifications as sid did
    and i finally got these 6280 unlocked
    thanks again to all for the support

    br
    sorinm
    i have still cant unlock 6280 plz pm what change and how Measured if it good or not

Slicne teme

  1. PROBLEM: Dongle not responding!
    Postovao Ivan u forumu JTAG Sagem Box
    Odgovori: 5
    Zadnji post: 08-04-09, 10:25
  2. Sagem update ! Sagdd now supports Rocker Dongle !
    Postovao legija u forumu Rocker Dongle
    Odgovori: 15
    Zadnji post: 22-12-07, 00:43
  3. rocker dongle problem kod instalacije
    Postovao imota u forumu Rocker Dongle
    Odgovori: 12
    Zadnji post: 06-11-07, 20:06
  4. Problem sa JAF-om
    Postovao dime u forumu J.A.F.
    Odgovori: 6
    Zadnji post: 16-06-07, 01:31

Pravila postovanja

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •